Unterschiede
Hier werden die Unterschiede zwischen zwei Versionen angezeigt.
| Beide Seiten der vorigen RevisionVorhergehende ÜberarbeitungNächste Überarbeitung | Vorhergehende Überarbeitung | ||
| en:berechnungen:verweilzeit [2024/10/17 20:11] – [Residence time] neelest | en:berechnungen:verweilzeit [2026/09/17 09:23] (aktuell) – gelöscht - Externe Bearbeitung (Unbekanntes Datum) 127.0.0.1 | ||
|---|---|---|---|
| Zeile 1: | Zeile 1: | ||
| - | ======Residence time====== | ||
| - | |||
| - | For the calculation of the residence time the same conditions as for the calculation of | ||
| - | the melting profile have to be fulfilled. In addition to this the injection time is required | ||
| - | with **PSI**. | ||
| - | |||
| - | **Realization of the theoretical principles** | ||
| - | |||
| - | The screw is divided into at least 150 parts for the residence time calculation. Up to | ||
| - | the point of melt pool formation (OSW), there is no difference between the calculation of the | ||
| - | minimum residence time and that of the average residence time, since a block flow is | ||
| - | assumed, here. From the point of melt pool formation (OSW) the residence time is calculated | ||
| - | with allowance for the current density. When the residence time calculated equals the | ||
| - | metering time calculated, the residence time and the injection time will be added. | ||
| - | This procedure is continued until the screw tip is reached. | ||
| - | |||
| - | ===Further topics=== | ||
| - | * [[en: | ||
| - | * [[en: | ||
| - | * [[en: | ||
| - | * [[en: | ||
| - | * [[en: | ||
| - | * [[en: | ||
| - | * [[en: | ||
| - | * [[en: | ||
| - | * [[en: | ||
| - | * [[en: | ||
| - | * [[en: | ||
| - | * [[en: | ||
| - | * [[en: | ||
| - | * [[en: | ||
| - | * [[en: | ||
| - | * [[en: | ||
| - | * [[en: | ||
| - | * [[en: | ||
| - | * [[en: | ||