Unterschiede
Hier werden die Unterschiede zwischen zwei Versionen angezeigt.
| Beide Seiten der vorigen RevisionVorhergehende ÜberarbeitungNächste Überarbeitung | Vorhergehende Überarbeitung | ||
| en:eingabe_der_maschinenparameter_und_konfiguration:schneckenelemente:gewindeelmente [2025/05/24 23:02] – deppe2 | en:eingabe_der_maschinenparameter_und_konfiguration:schneckenelemente:gewindeelmente [2025/08/17 01:22] (aktuell) – deppe2 | ||
|---|---|---|---|
| Zeile 11: | Zeile 11: | ||
| * Instead of the **Volume correction factor** newly added **Additional Values** can be entered. These are the **Real diameter** of the screw and the **Flight angle** or the **Base angle** (the angles are shown in the figure). You can enter either angle. The other one is calculated based on the entered one. | * Instead of the **Volume correction factor** newly added **Additional Values** can be entered. These are the **Real diameter** of the screw and the **Flight angle** or the **Base angle** (the angles are shown in the figure). You can enter either angle. The other one is calculated based on the entered one. | ||
| + | {{ : | ||
| **Figure:** Input mask threaded element | **Figure:** Input mask threaded element | ||
| + | {{ : | ||
| + | {{ : | ||
| **Figure:** Additional data | **Figure:** Additional data | ||