≪ View Page

Unterschiede

Hier werden die Unterschiede zwischen zwei Versionen angezeigt.

Link zu dieser Vergleichsansicht

Beide Seiten der vorigen RevisionVorhergehende Überarbeitung
en:eingabe_der_maschinenparameter_und_konfiguration:schneckenelemente:knetelemente [2025/08/17 01:21] – deppe2en:eingabe_der_maschinenparameter_und_konfiguration:schneckenelemente:knetelemente [2025/08/17 01:22] (aktuell) – deppe2
Zeile 12: Zeile 12:
 with i as **Number of flights** of the element. A negative angle identifies a reconveying kneading block, in contrast positive angle characterizes a conveying kneading block. Neutral kneading blocks are indicated by a Staggering angle of 180°/i. with i as **Number of flights** of the element. A negative angle identifies a reconveying kneading block, in contrast positive angle characterizes a conveying kneading block. Neutral kneading blocks are indicated by a Staggering angle of 180°/i.
  
-{{ :en:eingabe_der_maschinenparameter_und_konfiguration:schneckenelemente:en_sigma150_dlg_eingabe_der_maschinenparameter_und_konfiguration_schneckenelemente_003.png?nolink |}}+{{ :en:eingabe_der_maschinenparameter_und_konfiguration:schneckenelemente:en_sigma150_dlg_eingabe_der_maschinenparameter_und_konfiguration_schneckenelemente_004.png?nolink |}} 
 +{{ :en:eingabe_der_maschinenparameter_und_konfiguration:schneckenelemente:en_sigma150_dlg_eingabe_der_maschinenparameter_und_konfiguration_schneckenelemente_005.png?nolink |}}
 **Figure:** Input mask kneading block **Figure:** Input mask kneading block
  
 **Shouldered kneading blocks** possess smaller kneading discs than standard kneading blocks. That is why a bigger leakage gap comes into existence. SIGMA makes the assumption that the width of the shouldered kneading block discs is half the width of the standard kneading block discs. Hereby the input mask is the same as for standard kneading blocks. **Shouldered kneading blocks** possess smaller kneading discs than standard kneading blocks. That is why a bigger leakage gap comes into existence. SIGMA makes the assumption that the width of the shouldered kneading block discs is half the width of the standard kneading block discs. Hereby the input mask is the same as for standard kneading blocks.