Unterschiede
Hier werden die Unterschiede zwischen zwei Versionen angezeigt.
| Beide Seiten der vorigen RevisionVorhergehende ÜberarbeitungNächste Überarbeitung | Vorhergehende Überarbeitung | ||
| en:eingabe_der_maschinenparameter_und_konfiguration:schneckenelemente [2026/04/07 14:16] – [Screw Elements] pka | en:eingabe_der_maschinenparameter_und_konfiguration:schneckenelemente [2026/04/07 14:22] (aktuell) – [Kneading Elements] pka | ||
|---|---|---|---|
| Zeile 41: | Zeile 41: | ||
| ===== Pushing Flight Elements ===== | ===== Pushing Flight Elements ===== | ||
| - | The geometry of push edge elements differs from the geometry of conveyor elements only in that it has an additional free surface. In SIGMA, this surface is characterised by two parameters, the **angle of inclination** $$\phi_s$$ and the **radius of curvature r**. Otherwise, the same specifications as for conveyor and return elements apply. | + | The geometry of push edge elements differs from the geometry of conveyor elements only in that it has an additional free surface. In SIGMA, this surface is characterised by two parameters, the **angle of inclination** $$\phi_s$$ and the **radius of curvature r**. Otherwise, the same specifications as for conveyor and return elements apply. |
| {{ : | {{ : | ||
| {{ : | {{ : | ||
| Zeile 48: | Zeile 47: | ||
| ===== Threaded Mixing Elements (Conveying and Reconveying) ===== | ===== Threaded Mixing Elements (Conveying and Reconveying) ===== | ||
| - | Unlike conveyor elements, screw mixing elements have grooves cut into their flanks. In addition to the pitch and number of grooves, the geometry of the groove in the normal section must also be defined. To ensure maximum flexibility, | + | Unlike conveyor elements, screw mixing elements have grooves cut into their flanks. In addition to the pitch and number of grooves, the geometry of the groove in the normal section must also be defined. To ensure maximum flexibility, |
| {{ : | {{ : | ||
| Zeile 74: | Zeile 73: | ||
| {{ : | {{ : | ||
| - | Unlike conventional kneading blocks, **shoulder kneading block** have narrower kneading discs, which creates a larger leakage gap. In SIGMA, the width of the kneading discs of the shoulder kneading elements is assumed to be half the width of the conventional kneading blocks. It follows that the input masks for the two elements do not differ. | + | Unlike conventional kneading blocks, **shoulder kneading block** have narrower kneading discs, which creates a larger leakage gap. In SIGMA, the width of the kneading discs of the shoulder kneading elements is assumed to be half the width of the conventional kneading blocks. It follows that the input masks for the two elements do not differ. Further details about the geometry of shouldered kneading blocks can be found in the reference manual (s. [[en: |
| ===== Eccentric Kneading Elements ===== | ===== Eccentric Kneading Elements ===== | ||