Unterschiede

Hier werden die Unterschiede zwischen zwei Versionen angezeigt.

--- en:eingabe_der_schneckendaten:einzugs-_metering-_und_entgasungszone [2024/10/25 15:46] – neelest
+++ en:eingabe_der_schneckendaten:einzugs-_metering-_und_entgasungszone [2026/09/17 09:27] (aktuell) – gelöscht - Externe Bearbeitung (Unbekanntes Datum) 127.0.0.1
@@ Zeile 1: / Zeile 1: @@
-======Feed, Metering and Venting section======
-The input mask for sections with constant flight depth is identical for the feed section,
-the metering section and the venting section. The differentiation has only been made
-to specify the screw sections exactly and to set the diameter in the feed section. The
-geometrical parameters to be entered from the basis of the calculation algorithms are
-implemented in the program and must be defined completely.
-The following illustration shows the geometry of a single flight screw section.
-{{ :eingabe_der_schneckendaten:abb_kanalgeometrie_uebersicht_en.svg |}}
-^ Input identifier ^ Description   ^
-|L //or// L/D   | Length of the zone    |
-|δ (delta)  | Screw clearance |
-|i     | No. of flights |
-|r_1  | Radius active flight |
-|r_2  | Radius non active flight |
-|γ  (gamma) | Flight angle |
-|e   | Flight width |
-|t //or// t/D   | Pitch |
-| h_E, h_M, h_0    | Channel depth (**E**: Intake, **M**etering, **0**: Degassing)|
-The corresponding input screen (feed zone) with the required sizes is shown below:
-{{ :eingabe_der_schneckendaten:rex171_einzmetentg_en_001.png?nolink |}}
-Once all input variables have been defined, the following variables are calculated automatically:
-^ Calculated identifier ^ Description   ^
-| b    | Channel width   |
-|A_q     | Channel cross section |
-|V_K   | Channel volume |
-The dialogues of the metering and degassing zones differ only in the illustration and the designation of the aisle depth h_0 (degassing zone), h_M (metering zone).
-{{ :eingabe_der_schneckendaten:rex171_einzmetentg_en_002.png?nolink |}}
-{{ :eingabe_der_schneckendaten:rex171_einzmetentg_en_003.png?nolink |}}
-[[en:eingabe_der_schneckendaten:kompressions-_und_dekompressionszone|Continue to Compression and Decompression section]]