Unterschiede
Hier werden die Unterschiede zwischen zwei Versionen angezeigt.
| Beide Seiten der vorigen RevisionVorhergehende ÜberarbeitungNächste Überarbeitung | Vorhergehende Überarbeitung | ||
| en:eingabe_der_schneckendaten:kompressions-_und_dekompressionszone [2024/10/25 15:48] – neelest | en:eingabe_der_schneckendaten:kompressions-_und_dekompressionszone [2026/09/17 09:26] (aktuell) – gelöscht - Externe Bearbeitung (Unbekanntes Datum) 127.0.0.1 | ||
|---|---|---|---|
| Zeile 1: | Zeile 1: | ||
| - | ======Compression and Decompression section ====== | ||
| - | In addition to the information needed for the sections with a constant channel depth a | ||
| - | second channel depth must be entered with the compression and decompression | ||
| - | section. If for the channel depth h_1 a greater value is entered into the input mask of the | ||
| - | compression section than for the beginning channel width h_0 REX/PSI will change | ||
| - | this section automatically into a decompression section. This is also valid vice versa. | ||
| - | |||
| - | Another special feature is that a constant pitch does not have to be used, but can be specified separately for the start and end of the zone. A continuous change in the aisle gradient is calculated over the entire length of the zone. | ||
| - | |||
| - | {{ : | ||
| - | {{ : | ||
| - | |||
| - | ===Further topics=== | ||
| - | ==Input of the screw== | ||
| - | * [[en: | ||
| - | * [[en: | ||
| - | * [[en: | ||
| - | * [[en: | ||
| - | * [[en: | ||
| - | * [[en: | ||
| - | * [[en: | ||
| - | * [[en: | ||
| - | * [[en: | ||
| - | * [[en: | ||
| - | |||
| - | ==Input of shearing and mixing parts== | ||
| - | * [[en: | ||
| - | * [[en: | ||
| - | * [[en: | ||
| - | * [[en: | ||
| - | * [[en: | ||
| - | * [[en: | ||
| - | * [[en: | ||
| - | * [[en: | ||
| - | |||
| - | ==Non-return valves (PSI)== | ||
| - | * [[en: | ||
| - | * [[en: | ||
| - | * [[en: | ||
| - | * [[en: | ||