Unterschiede

Hier werden die Unterschiede zwischen zwei Versionen angezeigt.

--- en:eingabe_der_schneckendaten:mailleferzone [2024/07/13 14:52] – neelest
+++ en:eingabe_der_schneckendaten:mailleferzone [2026/09/17 09:23] (aktuell) – gelöscht - Externe Bearbeitung (Unbekanntes Datum) 127.0.0.1
@@ Zeile 1: / Zeile 1: @@
-======Maillefer section ======
-FIXME
-===== Maillefer section =====
-The Maillefer section is a special case of a barrier section. By contrast to barrier
-sections which are made up of at least three sections, only a single pitch is possible
-within the entire element.
-{{ :eingabe_der_schneckendaten:abb_maillefer_en.svg?700 |}}
-All geometry parameters affect the width of the solid channel at the start respectively
-the end and the width of the melt channel at the end of the Maillefer section. These
-cannot be edited. The width of the melt channel at the start of the Maillefer section
-b_s_MO has to be entered.
-What's more, at 1 is shown the design of the screw channel. The zones are
-separated by the vertical black lines. Illustrated from left to right one can see the
-previous section of the barrier section. Following the Maillefer section. The main flight
-is shown blue, the barrier flight is red. Finally, the illustration presents the following
-zone of the barrier section.
-The current section is bordered in black. In this case it is the inflow section. By sliding
-the cursor over the illustration, the type of each section appears in a bubblehelp.
-**Platzhalter für Abbildung 3.19 Nils**