≪ View Page

Unterschiede

Hier werden die Unterschiede zwischen zwei Versionen angezeigt.

Link zu dieser Vergleichsansicht

en:sigma3d-interface:schnellzugriff_ueber_scheckendarstellung [2025/05/13 15:27] – angelegt deppe2en:sigma3d-interface:schnellzugriff_ueber_scheckendarstellung [2025/05/28 12:19] (aktuell) – deppe2
Zeile 1: Zeile 1:
 ====== Quick access through displayed screw ====== ====== Quick access through displayed screw ======
 +
 +===== Quick access through displayed screw =====
 +
 +Alternatively, individual screw elements can be selected in the displayed screw configuration. By right clicking on an element a list appears including the option to create a SIGMA3D configuration.
 +
 + 
 +
 +
 +
 + 
 +
 +**Figure 14:** SIGMA3D configuration through quick access
 +
 + 
 +
 +For the three-dimensional simulation, the one-dimensional calculation should have been done before. This way the one-dimensional calculated material temperature at the desired screw position can be used for the three-dimensional simulation. By default the selected screw element and two elements upstream are selected in the configuration window. The only parameter that has to be set, is the clearance between the screws.
 +
 + 
 +
 +
 +
 + 
 +
 +**Figure 15:** SIGMA3D configuration through quick access
 +
 + 
 +
 + 
 +
 +==== Related themes: ====
 +  * General Information
 +  * Pre-Processing
 +  * Post-Processing
 +
 +